DGK Pellachrom | decorative and marine paints | - Header Section

DGK Pellachrom | decorative and marine paints | - Main Section

DGK Pellachrom | decorative and marine paints | - Main Component

water
SOLVENT BASED
  • 750 ml
  • 2.5 L

POLACRYL 345

polyurethane wood varnish for boats

Gloss polyurethane varnish with UV filters and HALS light stabilizers. Ideal for the protection of interior and exterior wood exposed to harsh weather conditions. Ideal for any wooden boat. Excellent resistance to the harsh tropical sun and to all marine and coastal conditions. Ideal solution for wood exposed to sunlight and humidity. Enhances wood's warm natural colour giving it a new fresh touch. Good ability to expand and contract with the wood due to the great elasticity of its film. Extremely resistant against adverse weather conditions and tear.

  • excellent waterproofing protection
  • with UV filters & HALS light stabilizers
  • resists yellowing
xrisi3xrisi3
BUILDINGS
INTERIOR-EXTERIOR USE
xrisi3
MARINE USE-FREEBOARDS
highgloss
Finish
toolsall
TOOLS
POLACRYL 345
THINNING
2-3 hr
DRYING TIME
24 hrs
OVERCOATING INTERVAL
2- 3
RECOMMENDED COATS
14 2
m2/L
SPREADING RATES

Preparation

Surfaces must be clean, free of resins, oil, old weathered coatings and dust. Sand surface smooth using the right sandpaper for the task. Surface should not be cleaned with water before varnish application.

New wood:
Apply 1-3 coats of POLACRYL 301. Allow to dry completely, sand lightly, remove sanding residue with a rag and apply 2-3 coats of POLACRYL 345, thinned with W.S. by 5-20%. If POLACRYL 301 is not used, thin POLACRYL 345 with W.S. by 40-50% for the 2 first coats. Allow to dry, sand and apply 2-3 final coats after thinning it with W.S. by 5-20%.
Old wood:
Sand and remove sanding residue with a rag. Use POLACRYL 305 to fill large gaps and cracks. Apply 2-3 coats of POLACRYL 301 depending on the absorbency of the wood. Apply 2-3 coats of POLACRYL 345 (thinned by 5-20%).
Poor quality wood:
Remove old paints down to bare wood. Sand and remove sanding residue with a rag. Then, follow the instructions for new wood.
Teak & Greasy Wood:
Clean the surface with acetone or xylene. Allow to dry. Apply 2 coats of POLACRYL 301 (apply the next coat when the varnish is slightly sticky to the touch). Allow to dry, sand and clean thoroughly. Apply 3-4 coats of POLACRYL 345 (thinned by 5-20%) depending on the needs of the wood.

Use

► Surface humidity must not be over 18%.
► Do not apply when ambient temperature and wood temperature is below 10°C and when relative humidity is high.
► Shake or stir well before use.
► Sand surface smooth with the right sandpaper for the task before painting.
► To avoid bubble forming during application, try to work in a shaded area.

Drying out - coverage

Drying times are dependent on ambient temperature and film thickness.

Touch dry: 2-3 hours.

Recoat: 24 hours.

Practical coverage: 12-16m²/lt depending on the thickness of each coat and the surface porosity.

DGK Pellachrom | decorative and marine paints | - Bottom info

Calculate the quantity of the paint

you need for