DGK Pellachrom | decorative and marine paints | - Header Section

DGK Pellachrom | decorative and marine paints | - Main Section

DGK Pellachrom | decorative and marine paints | - Main Component

water
WATERBASED
  • 1 L
  • 5 L
  • 10 L

FERM H2O

acrylic micro-molecular micronized water-based primer

Transparent acrylic micronized water-based primer, ideal for interior and exterior use. Suitable for the preparation of absorbing surfaces, such as gypsum boards, fine- grained repair mortar for walls, puttied walls, plaster, MDF, concrete, and for horizontal and vertical surfaces (flat terraces, etc.). Strengthens and isolates old previously painted surfaces. Ideal undercoat for emulsion, acrylic and insulating paints. Ensures better adhesion and flow of the top coat. Impregnates and stabilizes alkaline surfaces. The number of coats depends on the type of the surface and its use. Almost odorless, user and environment friendly. Suitable as a primer for interior areas and in particular, for confined spaces. Ideal for the preparation of children’s rooms, hospitals and schools.

  • odorless, ideal for interior and exterior surfaces
  • strong adhesion
  • isolating and waterproofing
xrisi2xrisi2
BUILDINGS
INTERIOR-EXTERIOR USE
satin
Finish
toolsall
TOOLS
1-2 hr
DRYING TIME
4-6 hrs
OVERCOATING INTERVAL
1- 2
RECOMMENDED COATS
14 2
m2/L
SPREADING RATES

Preparation

Carefully prepare surface to obtain good results. Remove all weathered-peeled off coatings, dust, oils, salts and mildew. Surface must be clean and dry.

New plaster, concrete, brick, cement (flat terraces):
Prime with FERM (H2O) thinned up to 50% with water.
New gypsum board or putty:
Prime with FERM (H2O) thinned from 50-100% with water.
Old water-based or lime paints:
Prime with FERM (H2O) thinned up to 100% with water.

Use

Roller, brush or spray airless. Thin by 30-100% with water.

► Stir well before and during application.
► Apply 1 coat of FERM (H2O) thinned with water by 100%. In case of very absorbing surfaces, thin with water up to 50%.
► Properly thin to prevent the creation of a film on the surface. In case of absorbing surfaces, apply additional coats.
► Allow newly poured concrete to cure for 30 days, then prime with FERM (H2O).

Drying out - coverage

Drying times are dependent on ambient temperature and film thickness.

Touch dry: 1-2 hours.

Recoat: 4-6 hours.

Practical coverage: 12-16m²/lt depending on the thickness of each coat and the surface porosity.

DGK Pellachrom | decorative and marine paints | - Bottom info

Calculate the quantity of the paint

you need for