DGK Pellachrom | decorative and marine paints | - Header Section

DGK Pellachrom | decorative and marine paints | - Main Section

DGK Pellachrom | decorative and marine paints | - Main Component

water
SOLVENT BASED
  • 375 ml
  • 750 ml

SMALTO GRIP

varnish & primer for non-absorbing surfaces

Varnish – primer with very good adhesion to non absorbing surfaces, such as glass, tiles, enamel, aluminium, marble. Easy to use, no thinning required. Numerous applications as a primer on two-part polyurethane products. Ideal for bathroom renovation projects in houses and hotels.

  • high coverage
  • easy to apply
  • strong adhesion
xrisi2xrisi2
BUILDINGS
INTERIOR-EXTERIOR USE
gloss
Finish
toolsall
TOOLS
1-2 hr
DRYING TIME
24 hrs
OVERCOATING INTERVAL
1- 2
RECOMMENDED COATS
15 2
m2/L
SPREADING RATES

Preparation

Carefully prepare surface to obtain good results. Surface must be clean, dry and free from defective or non-cohesive material, dust, oils, soap, shampoo residue and salts. Clean the surface thoroughly using a stiff bristle brush and soap water. Rinse-off well and allow to dry before degreasing the surface with a thinner soaked rag.

New glass, tiles, enamel, aluminium, marble:
Apply SMALTO GRIP on a completely dry and clean surface. Normally, one coat is enough. Allow to dry completely (12-24 hours). Apply 1 coat of POLYGLOSS and 1 coat of POLYGLOSS + ADDITIVE 640.
Old glass, tiles, enamel, aluminium, marble:
Apply SMALTO GRIP on a completely dry and clean surface. Normally, one coat is enough. Allow to dry completely (12-24 hours). Apply 1 coat of POLYGLOSS and 1 coat of POLYGLOSS + ADDITIVE 640.
Old non absorbing tiles, enamel and marble:
If you wish to varnish the surface, apply 2 coats of SMALTO GRIP on a completely dry and clean substrate.

Use

► Stir well before use.
► To prevent bubble forming during application, work in an area protected against direct sunlight if possible.
► Do not apply when ambient temperature and surface temperature is below 10°C and when relative humidity is high.
► Do not allow more than 5 hours to apply the next coat.
► For a non-skid finish, allow SMALTO GRIP to dry and apply 1 coat of ANTISKID where anti-slip protection is required.

Drying out - coverage

Drying times are dependent on ambient temperature and film thickness.

Touch dry: 1-2 hours.

Recoat: 24 hours.

Practical coverage: 13-17m²/lt depending on the thickness of each coat and the surface porosity.

DGK Pellachrom | decorative and marine paints | - Bottom info

Calculate the quantity of the paint

you need for