DGK Pellachrom | decorative and marine paints | - Header Section

DGK Pellachrom | decorative and marine paints | - Main Section

DGK Pellachrom | decorative and marine paints | - Main Component

water
SOLVENT BASED
  • 750 ml
  • 3.5 L

ANTISKID

anti-slip polyurethane two-pack paint

Premium anti-skid two-part polyurethane top coat, extremely resistant to adverse weather conditions. Its composition ensures strong adhesion on all surfaces. Ideal for indoor and outdoor use. Excellent yellowing resistance. Apply on boat decks, windsurf boards, ramps, courts, steps, pools, steps, etc.

  • resistance to strong chemical
  • strong adhesion
  • extreme chemical and mechanical resistance
xrisi3xrisi3
BUILDINGS
INTERIOR-EXTERIOR USE
xrisi3
MARINE USE-FREEBOARDS
relief
Finish
toolsall
TOOLS
ANTISKID
THINNING
1-2 hr
DRYING TIME
12 hrs
OVERCOATING INTERVAL
2- 3
RECOMMENDED COATS
4 2
m2/L
SPREADING RATES
water READY TO USE COLOR SHADES
900
901
902
903
904
905
906
907

Preparation

Carefully prepare surface to obtain good results. Remove all weathered coatings, rust and oils. Sand surface smooth and remove sanding residue with a rag.

New polyester:
Degreasing new polyester is of utmost importance. Please follow the proposed procedure: Wash surface with warm water and soap (detergent). Rinse well, allow to dry and clean using a thinner. Sand surface smooth and remove sanding residue with a whisk and a thinner soaked rag. The surface is now ready to be painted. Any other surface preparation method could trap grease inside the surface thus, rendering painting impossible. Prime with UNI-PRIMER, 1-2 coats. Apply 2 coats of ANTISKID.
New plaster, concrete, brick, cement and stone:
If insulation is required, apply POLACRYL 301 until surface saturation is achieved. Apply 2-3 coats of ANTISKID.
New wood:
Apply POLACRYL 301 until surface saturation is achieved. Apply 2-3 coats of ANTISKID.
New metal:
Prime with X-RUST, 2 coats. Apply 2-3 coats of ANTISKID.
New glass, tiles, enamel plates:
Prime with SMALTO GRIP, 1-2 coats. Apply 2-3 coats of ANTISKID.
Recoated old surfaces:
Prime with UNI-PRIMER, 1-2 coats, where necessary. Apply 2-3 coats of ANTISKID.

Use

► Make sure your tool has the adequate quantity of paint to cover an entire section. This practice should be strictly followed to obtain optimum results.
► Do not apply when ambient temperature and surface temperature is below 10°C, above 35°C or when relative humidity is above 70% and surface humidity is above 4%.
► Adequate ventilation must be ensured due to the hazardous fumes generated during paint application.

Drying out - coverage

Drying times are dependent on ambient temperature and film thickness.

Touch dry: 1-2 hours.

Recoat: 12 hours.

Practical coverage: 2-6m²/lt depending on the thickness of each coat and the surface porosity.

DGK Pellachrom | decorative and marine paints | - Bottom info

Calculate the quantity of the paint

you need for