DGK Pellachrom | decorative and marine paints | - Header Section

DGK Pellachrom | decorative and marine paints | - Main Section

DGK Pellachrom | decorative and marine paints | - Main Component

water
SOLVENT BASED
  • 750 ml
  • 2.5 L

UNI-PRIMER

polyurethane two-pack primer

High-quality two-pack polyurethane primer for the protection of particularly demanding surfaces. Ideal for boat topsides and hulls. Ideal undercoat for a long-lasting painting system when combined with POLYGLOSS, TROPIKAL, ANTISKID, POOLGLOSS, MONOTRETEN products. Due to its formulation, levels out any irregularities on the substrate. Easy to apply and quick-drying. Ideal for marine use or for interior/exterior wood, polyester or cement.

  • strong adhesion
  • great filling capacity
  • extreme chemical and mechanical resistance
xrisi4xrisi4
BUILDINGS
INTERIOR-EXTERIOR USE
xrisi4xrisi4
FREEBOARDS - UNDERWATER HULL
matt
Finish
toolsall
TOOLS
UNI-PRIMER
THINNING
1 hr
DRYING TIME
4-6 hrs
OVERCOATING INTERVAL
1- 2
RECOMMENDED COATS
12 2
m2/L
SPREADING RATES
water READY TO USE COLOR SHADES
860
863
862
861

Preparation

Carefully prepare surface to obtain good results. Remove all weathered coatings, rust and oils. Sand surface smooth and remove sanding residue with a rag.

New polyester:
Degreasing new polyester is of utmost importance. Please follow the proposed procedure: Wash surface with warm water and soap (detergent). Rinse well, allow to dry and clean using a thinner. Sand surface smooth and remove sanding residue with a whisk and a thinner soaked rag. The surface is now ready to be painted. Any other surface preparation method could trap grease inside the surface thus, rendering painting impossible. Prime with UNI-PRIMER, 1-2 coats.
New plaster, concrete, brick, cement:
Apply POLACRYL 301 until surface saturation is achieved. Prime with UNI-PRIMER, 1-2 coats.
New wood:
Apply POLACRYL 301 until surface saturation is achieved. Prime with UNI-PRIMER, 1-2 coats.
Recoated old surfaces:
Sand surface smooth. Apply 1-2 coats of UNI-PRIMER.

Use

► Stir well component A before use to achieve homogeneity. Then, add component B progressively while constantly stirring.
► Make sure your tool has the adequate quantity of paint to cover an entire section. This practice should be strictly followed to obtain optimum results.
► Sand surface smooth with the right sandpaper for the task before painting.
► To prevent bubble forming during application, work in an area protected against direct sunlight if possible.
► Do not apply when ambient temperature and surface temperature is below 10°C, above 35°C and when relative humidity is above 70%.
► Adequate ventilation must be ensured due to the hazardous fumes generated during paint application.
► Allow UNI-PRIMER to dry. Sand surface smooth and remove sanding residue. Then, paint with the two-pack polyurethane paint of your choice (POLYGLOSS, ANTISKID, POOLGLOSS, MONOTRETEN) or with TROPIKAL antifouling paints.

Drying out - coverage

Drying times are dependent on ambient temperature and film thickness.

Touch dry: 1 hour.

Recoat: 4-6 hours.

Practical coverage: 10-14m²/lt depending on the thickness of each coat and the surface porosity.

DGK Pellachrom | decorative and marine paints | - Bottom info

Calculate the quantity of the paint

you need for