SOLVENT BASED

POLYFLOOR

two part polyurethane paint for floors

Premium high-hiding, fast drying two-part polyurethane coating for unpainted or previously painted concrete floors. Weather resistant. Adheres tightly to concrete surfaces, resists chalking and peeling. Superior hardness. High friction resistance. Particularly resistant to chemicals and abrasion. Ideal for industrial areas, indoor and outdoor floor surfaces.

high chemical & mechanical strength
U.V. long resistance
excellent adhesion

BUILDINGS
INTERIOR-EXTERIOR USE

satin

Finish

TOOLS

THINNING

1-2 hr

DRYING TIME

6-12 hrs

OVERCOATING INTERVAL

2- 3

RECOMMENDED COATS

7		2
m²/L

SPREADING RATES

READY TO USE COLOR SHADES

980

Preparation

For best results, careful surface preparation is required. Surfaces to be painted must be clean, dry, free from weathered matter, loose and scalling paint, dust, oil and salt. Careful preparation is essential for good adhesion.

New concrete or cement mortar surfaces: Allow one month at least after construction before painting. Surfaces must be dry and free from damp and dust. Apply 10% of solution of muriatic acid to open up the pores and provide a tighter bond for the paint. Pour solution on surface and brush it until acid ceases to effervesce. Wash off muriatic acid with plenty of clean water and scrub the surface to remove all foreign matter. Allow to dry at least one week before painting. Previously painted surfaces: Remove any dirt and weathered matter by wire-brushing. Wash off with plenty of water. Surfaces must be dry before painting.

Use

Stir part A thoroughly prior to use to obtain a homogeneous mix and then add part B to a ratio 2.5/1 by volume (mix limit life at +20⁰C: 6 hours). Thin with Thinner 120 by 5-20%. Apply 2-3 coats using a brush, short-napped roller or for best results using a spray-gun. Minimum application temperature: 10⁰C. Avoid application at temperatures higher than 30⁰C. After application of thelast coat, allow 7-10 days to achieve full coating properties' development.

Drying out - coverage

Touch dry in 1-2 hours. Overcoat after 6-12 hours depending on ambient temperature-humidity and the thickness of the coat. Covers 5-9m²/lt depending on the thickness of each coat and the surface absorption capacity.