Preparation
Carefully prepare surface to obtain good results. Remove all weathered coatings, rust and oils. Sand surface smooth and remove sanding residue with a rag.
► New polyester:
Degreasing new polyester is of utmost importance. Please follow the proposed procedure: Wash surface with warm water and soap (detergent). Rinse well, allow to dry and clean using a thinner. Sand surface smooth and remove sanding residue with a whisk and a thinner soaked rag. The surface is now ready to be painted. Any other surface preparation method could trap grease inside the surface thus, rendering painting impossible. Prime with UNI-PRIMER, 1-2 coats. Apply 2 coats of ANTISKID.
► New plaster, concrete, brick, cement and stone:
If insulation is required, apply POLACRYL 301 until surface saturation is achieved. Apply 2-3 coats of ANTISKID.
► New wood:
Apply POLACRYL 301 until surface saturation is achieved. Apply 2-3 coats of ANTISKID.
► New metal:
Prime with X-RUST, 2 coats. Apply 2-3 coats of ANTISKID.
► New glass, tiles, enamel plates:
Prime with SMALTO GRIP, 1-2 coats. Apply 2-3 coats of ANTISKID.
► Recoated old surfaces:
Prime with UNI-PRIMER, 1-2 coats, where necessary. Apply 2-3 coats of ANTISKID.