DGK Pellachrom | decorative and marine paints | - Header Section

X

DGK Pellachrom | decorative and marine paints | - Main Section

DGK Pellachrom | decorative and marine paints | - Main Component

water
SOLVENT BASED
  • 750 ml
  • 2.5 L

X-RUST

Header

anti-corrosive polyurethane two-pack primer

Anti-corrosive polyurethane two-pack undercoat for new or previously coated metal surfaces, weathered galvanized surfaces and other exterior and interior metal surfaces. Its strong anti-corrosive pigments protect metal surfaces against corrosion and rust in coastal environment or below the water line. Ideal for marine use and superstructures. Ensures a smooth surface for premium finish. Ideal undercoat for POLYGLOSS, ANTISKID polyurethane topcoats and TROPIKAL antifouling paints.

  • outstanding anti-corrosive protection
  • strong adhesion
  • extreme chemical and mechanical resistance
xrisi4xrisi4
BUILDINGS
INTERIOR-EXTERIOR USE
xrisi4xrisi4
FREEBOARDS - UNDERWATER HULL
satin
Finish
toolsall
TOOLS
X-RUST
THINNING
1 hr
DRYING TIME
2-4 hrs
OVERCOATING INTERVAL
2
RECOMMENDED COATS
12 sin plin 2
m2/L
SPREADING RATES
water READY TO USE COLOR SHADES
895

Preparation

Carefully prepare surface to obtain good results. Surface must be clean, dry and free from loose or flaking material, dust, oils and salts.

► New metal:
Degrease using THINNER 120. Prime with X-RUST, 2 coats.
► Previously painted metal surfaces:
Sand surface smooth and prime with X-RUST, 2 coats.

Use

► Stir well component A before use to achieve homogeneity. Then, add component B progressively while constantly stirring.
► Make sure your tool has the adequate quantity of paint to cover an entire section. This practice should be strictly followed to obtain optimum results.
► Sand surface smooth with the right sandpaper for the task before painting.
► To prevent bubble forming during application, work in an area protected against direct sunlight if possible.
► Do not apply when ambient temperature and surface temperature is below 10°C, above 35°C and when relative humidity is above 70%.
► Adequate ventilation must be ensured due to the hazardous fumes generated during paint application.
► Allow X-RUST to dry. Sand surface smooth and remove sanding residue. Then, paint with the two-pack polyurethane paint of your choice (POLYGLOSS, ANTISKID, MONOTRETEN) or with TROPIKAL antifouling paints.

Drying out - coverage

Drying times are dependent on ambient temperature and film thickness.

Touch dry: 1 hour.

Recoat: 2-4 hours.

Practical coverage: 10-14m²/lt depending on the thickness of each coat and the surface porosity.

Download PDF Technical Data Sheet - X-RUST A+B | Anti-corrosive polyurethane two-pack primer

DGK Pellachrom | decorative and marine paints | - Bottom info

Calculate the quantity of the paint

you need for

Your Home

Your Boat