DGK Pellachrom | decorative and marine paints | - Header Section

DGK Pellachrom | decorative and marine paints | - Main Section

DGK Pellachrom | decorative and marine paints | - Main Component

water
SOLVENT BASED
  • 750 ml
  • 2.5 L

ANTIRUST EPOXY

Header

anti-corrosive epoxy two-pack primer

Anti-corrosive epoxy two-pack undercoat for new or previously coated metal surfaces, weathered galvanized surfaces and other exterior and interior metal surfaces. Its strong anti-corrosive pigments protect metal surfaces against corrosion and rust in coastal environment or below the water line. Ideal for marine use and superstructures. Ensures a smooth surface for premium finish. Ideal undercoat for POLYGLOSS, ANTISKID polyurethane topcoats and TROPIKAL antifouling paints.

  • outstanding anti-corrosive protection
  • strong adhesion
  • extreme chemical and mechanical resistance
xrisi4xrisi4
BUILDINGS
INTERIOR-EXTERIOR USE
xrisi4xrisi4
FREEBOARDS - UNDERWATER HULL
satin
Finish
toolsall
TOOLS
ANTIRUST EPOXY
THINNING
1 hr
DRYING TIME
2-4 hrs
OVERCOATING INTERVAL
2
RECOMMENDED COATS
12 sin plin 2
m2/L
SPREADING RATES
599
599

Preparation

Carefully prepare surface to obtain good results. Surface must be clean, dry and free from loose or flaking material, dust, oils and salts.

► New metal:
Degrease using THINNER 125. Prime with ANTIRUST EPOXY, 2 coats.
► Previously painted metal surfaces:
Sand surface smooth and prime with ANTIRUST EPOXY, 2 coats.

Use

► Stir well component A before use to achieve homogeneity. Then, add component B progressively while constantly stirring.
► Make sure your tool has the adequate quantity of paint to cover an entire section. This practice should be strictly followed to obtain optimum results.
► Sand surface smooth with the right sandpaper for the task before painting.
► To prevent bubble forming during application, work in an area protected against direct sunlight if possible.
► Do not apply when ambient temperature and surface temperature is below 10°C, above 35°C and when relative humidity is above 70%.
► Adequate ventilation must be ensured due to the hazardous fumes generated during paint application.
► Allow X-RUST to dry. Sand surface smooth and remove sanding residue. Then, paint with the two-pack polyurethane paint of your choice (POLYGLOSS, ANTISKID, MONOTRETEN) or with TROPIKAL antifouling paints.

Drying out - coverage

Drying times are dependent on ambient temperature and film thickness.

Touch dry: 1 hour.

Recoat: 2-4 hours.

Practical coverage: 10-14m²/lt depending on the thickness of each coat and the surface porosity.

DGK Pellachrom | decorative and marine paints | - Bottom info

Calculate the quantity of the paint

you need for